The only hint at a fancy extra is the light indicator on the front of the floorhead.
If you notice any larger clogs, then you’ll need to make sure they are removed.Loose clogs can often be removed by hand, although you may need to use a narrow brush or compressed air for awkward locations.. Where to Check for Clogging.
Some of the most common locations for clogs include:.Where the wand meets the vacuum body on a stick vacuum.The entrance to the main tube from the floorhead.
The inside of the hose (see step three).The gap between the filter and the edge of the dust bin (for cyclonic vacuums).
The type of debris also affects how likely it is for clogs to form.
Damp dirt can quickly cause clogs, so try to avoid vacuuming anything that’s even slightly wet.In most cases, we recommended leaving the filter to air dry for around 24 hours.. It’s vital not to put a wet (or even damp) filter back into the Gtech Multi Mk2.
Doing so could allow water to reach the motor, which can cause serious damage (and risk an electric shock).. A damp filter is also the perfect environment for mould and milder to grow..Step 4: Re-Insert The Filter And Replace the Bin.
Once the filter has fully dried, re-insert it into the bin and reattach the bin to the vacuum body..Your Gtech Multi Mk2 is now ready to use!.
(Editor: Foldable Goggles)